Mold Remover- Tool for removing mold
A special detergent on an acid-water basis for removing mold
Mold Remover is a tool for cleaning hard surfaces, such as floors and building coverings made of marble, granite, terracotta, ceramics and concrete. Mold remover is a specific ally for removing mold, algae, moss and organic contaminants. Especially suitable for removing mold, algae, moss and other organic contaminants. The product works washed with water.
Mold Remover is a tool for cleaning hard surfaces, such as floors and walls of buildings, marble, granite, terracotta, ceramics and concrete. Mold Remover is a specific ally for removing mold, algae, moss and organic dirt. It is especially suitable for removing mold, algae, moss and other organic contaminants. The product should be rinsed with water.
- acid detergent / acid detergent
- quickly removes mold, algae, moss / removes mold, algae, moss
- removes organic pollution
- ideal for wet environments and outdoors / ideal for wet
- external environment
INSTRUCTIONS FOR USE / INSTRUCTIONS FOR USE
Remove any coarse dirt that may be present on the surface.
Apply the product to the surface to be treated with a brush or sponge. The product layer covering the surface should be at least 1 millimeter.
Leave the product in contact with the surface for different times depending on the degree of contamination. On average, it recommends leaving the product on for 30-60 minutes at 20°C for heavily soiled surfaces.
For slightly dirty surfaces or with higher temperatures, it is advisable to reduce the application time to avoid drying of the product. During this time, the disinfecting effect of the surface also occurs.
Wash with water. Depending on the surface treatment (sanded or brushed), the degree of contamination (significant organic residues, mold, etc.), during washing, use a brush to remove dirt from the porosity of the surface. It is possible to use a washing machine (single-brush or washer-dryer).
In case of heavy contamination, repeat the treatment in the same way. For greater effect with a clean and sharp dry surface, we recommend Tenax Protectant and/or Reviver, depending on the desired effect.
On some very shiny or delicate materials, such as onyx, the product may tarnish. It is good practice to test it on a corner of the material to determine the gloss and color fastness and to set the contact time correctly.
Sweep up any loose dirt. Spread the product liberally over the treated surface using a brush or sponge.
The thickness of the product layer covering the surface should be at least 1 mm.
Leave the product on the surface for the necessary time, depending on the degree of contamination. We recommend an average time of 30-60 minutes at 20°C for heavily soiled surfaces.
In case of less contamination or high temperature, reduce the time to prevent the product from drying out. During this time, the product also disinfects the surface. Wash with water. Depending on the roughness of the surface (smooth or polished), the type of contamination (organic residues, mold, etc.), during washing, use a brush to remove dirt from the porosity of the surface. The product can be applied with a cleaning machine.
In case of heavy contamination and insufficient cleaning, repeat the treatment in the same way. In order to protect the surface to continue and enhance the appearance, we suggest you combine this treatment with a Tenax protector or enhancer.
Apply to a perfectly dry surface. During the first treatment of the surface, it is advisable to check its effect on a sample or a hidden corner. On some very shiny or soft pieces, such as Onix, the detergent may cause a partial loss of luster.
